How to Reboot, Reformat, and Restore your Zune device (Now Includes Zune HD)
Many sync problems can be fixed by simply rebooting the device, reformatting it, or reinitializing it. Here is a list of the device commands for both V1/V2 and Zune HD devices. Try these actions first if you are having a problem with syncing to your Zune device.
Zune HD: Press and hold power button (button on top of the device) for 10 seconds
Zune30/4/8/16/80/120 Devices: Press and hold the Back button (<-) + Up on the directional pad at the same time
Format Device from the Zune software (All devices):
Go to Settings > Device > Sync Options > Then click the "erase all content" button.
Zune HD: Press the power button once
Zune HD: To power off, hold the power button for 3 seconds then pull down on the screen saver
Zune30/4/8/16/80/120 Devices: Press and hold Back + Down
Initializing and formatting your Zune HD Device:
To Initialize/Format - Reboot device (turn the device completely off) then when turning the device back on hold the home (center) button and media button(on the side) at the same time. This will delete all content off of the device and allows firmware reinstall.
To enter Recovery mode – Press and hold the power and media buttons for 15 seconds. The device reboots into Recovery mode (content is not erased, allows for firmware reinstall). This is a good option if you want to keep the content on your device, but reinstall the firmware.
Formatting and reinitializing your Zune30/4/8/16/80/120 Devices:
To perform the following, you must first reboot your device (hold the back button and up), and then when the screen goes black, hold the corresponding buttons until the process begins. (“OK” refers to pressing the center of the D-Pad/Z-Pad.)
Clear Content (Format from Device) – Clears all media content from the device, but leaves the firmware intact.
V1 Devices (Zune 30): Press and hold Back + Right + OK
V2 Devices (Zune 4/8 and 80): Press and hold Back + Play/Pause
Initialize Disk – Removes the content and the firmware. Device will be inoperable until connected to a PC so new firmware can be installed.
V1 Devices (Zune 30): Press and hold Back + Left + OK
V2 Devices (Zune 4/8 and 80): Press and hold Back + OK + Play/Pause
'TECH' 카테고리의 다른 글
|소니 이북리더 PRS-T1 hard reset (0)||2015.10.08|
|소니 이북리더 PRS-T1 스펙 (0)||2015.10.07|
|소니 이북리더 PRS-T1 Red 지름신고 (2)||2014.02.23|
|소니 이북리더 PRS-T1 지름신고 (0)||2014.01.25|
|LG 포켓포토 (5)||2013.09.22|
|How to Reboot, Reformat, and Restore your Zune device (Now Includes Zune HD) (0)||2013.02.21|
|iOS 6.1 탈옥 (0)||2013.02.05|
|오딘(Odin)으로 갤럭시 S2 젤리빈 업그레이드 (2)||2013.02.04|
|VMware 공유폴더 드라이브로 설정 (0)||2013.01.31|
|고스트 복원 후 Invalid partition table 발생시 (0)||2013.01.18|
|Zune HD와 쿼드비트 (0)||2013.01.13|